VULCANIC

ATEX FLANGE HEATER 260kW 480V 3PH

260kW 480V 3Ph Flange Heater according to GA Drawing No. 6046605 Rev00: - ATEX certified, II 2 G Ex de IIC T1 Gb - 54 removable Heating cartridges Ø16 mm installed in stainless steel pockets. - 10" 600# RF Flange in painted carbon steel - Terminal box IP66, Ex "d+e" type for power and control - 2 x K-type thermocouple fitted on pin for element over temperature control. Items delivered with one gasket. Special conditions must be taken to allow the safe use of this equipment. Refer to the instructions manual. Requirements for a safe use : - The safety device monitoring the surface temperature of the heating elements must avoid the overheating of the external parts of the equipment in contact with the hazardous atmosphere, and must switch off the power supply according to a wiring diagram with positive safety (a manual reset is necessary). If necessary, a forced cooler must be installed to prevent this overshoot (pressurized air, blower...). - To heat gas in vacuum conditions is prohibited. - Precautions must be taken so that the heating part is never in contact with an explosive mixture. When a non-inert gas is heated, a gas analyzer should be installed, which switch off the power supply according to a wiring diagram with positive safety (a manual reset is necessary). - The maximum temperature of the gas to be heated and the set point of the safety devices must comply with the data of the instructions manual. Immersion heaters are designed, manufactured and tested to fulfil the main safety requirements of the PED 2014/68/EU (appendix I). Consequently, they can be installed on a pressure vessel subjected to the PED, until the risk of category IV, within the applicable limits PS, max TS and min TS.

Get a quote now for VULCANIC ATEX FLANGE HEATER 260kW 480V 3PH. We will send you the price offer within 24 hours. If you send us the other products you are looking for but cannot find on our website, we can supply them for you.